`   `

-----Original Message-----
From: Mark
To: info@internetmarketingnw.com
Subject: Seconds of Arc

Reading your page with great interest I wonder how or where you are getting these very precise coordinates from. The example regarding Stonehenge is fascinating but you use tiny fractions of an arc second in your GPV calculations. Where do these numbers originate?

When talking about 0.3529411 of an arc second you are defining a point which I suspect is smaller than a pea and it is not possible to achieve this accuracy with GPS or Ordnance Survey Maps, navigation charts, etc. Do these numbers after the decimal point have to be created by you in order to reach a total ( in this case 21,600) or have I missed something? This is not a cynical enquiry, I am trying to understand your system more fully.

Thanks,

Mark

Mark:

I think you have it all backwards. True enough, we cannot calculate GPS positions out to 7 or 8 decimal positions in terms of seconds of arc (unless we get into micrometers - which too few know how to use anymore).

Your concern is with Stonehenge's 21,600 - which it SHOWS.

Its 360-degree plan represents the earth sphere and the 60 perimeter stones convey the language (60 seconds = 60 minutes = 60 degrees) of latitude/longitude.

Somewhere in the Matrix is a site which must explain it.

Purge the ancient for a monument showing both the numbers 60 and 360.

Up pops Stonehenge at 51° 10' = 42.35" of  latitude which CAN be verified on a large scale government topographical map.

The grid number shown by the site (21, 600) divides down through the 51 degrees and 10 minutes to 42.35294117 seconds, hence the map finds the site - dead on.

All those extra decimal places serve only to true up the site's position on the MATH side of the search which is, in fact, where Stonehenge centers itself. If all these decimal places serve to irritate, drop all but the first two. The message will get through anyway. The artifact at 21,600 has been found.

It's the same with the Mars Face. A circular ground plan (360°) with FOUR features (2 eyes, a nose and a mouth). 360 x 4 = 1440. But that's not where it is. Then too, the Great Pyramid. Four 90° corners and 4 sides...

4  x  90 = (360) x 4 = 1440.

Now we know that the Great Pyramid models the pi ratio (see page 21 of my Whispers From Time-I). Big puzzle...

Until we go inside the pyramid where we find that its passageways up and down are at an angle of 26° 18' 09.66", hence:

26°  x  18' x  09.66" = 4520.88 - which is just a whisker away from the combination of 1440 (Great Pyramid's basic form) and PI which it models in 3-D...

1440  x  PI  =  4523.89342115

This allows us to true up inclines within the pyramid proper:

4523.89342115 : 26° : 18' = 09.66643893405"

in order to achieve the 1440-pi MODELED by the pyramid.

What's so important about this particular quantity? Good food for mathematicians to ponder perhaps, but it can likewise do this...

4523.89342115 : 41° : 11' = 10.0308058l" North

Again, drop the extra numbers if you like, but the message got through anyway because this is where someone left us that Face over on Mars - at 1440-pi, hence its l440 TIMES pi - and the parallel crosses right over its NOSE.

My next Newsletter (#72) will take a closer look at the meaning. Thanks.

C.P.M.